Milkymist One RC2 PCB Specification

This page is under maintaining.

PCB Specification

MM1 RC1 pcb definition of stack up.

In general, your pcb specifications needed to be defined well at initial stage of kicking off project. So you can just list specifications as below with your final gerber files enclosed an engineering confirmation checklist, and all send them out. Your pcb maker will make pcb for you.

• Six Layers PCB
• Board Dimensions 150mm x 125mm in piece, 158mm x 133mm in panel
• 10mil drill via hole pth
• top & bot line width/line clearance, 5mils/5mils
• top & bot 5mil annular rings
• 1.6mm +- 0.05 mm thickness.
• FR4
• Components placed on TOP & BOT layer.
• Stacking of layers: 1st layer Top/Compnents/Signals, 2nd layer Gnd, 3rd layer Signal, 4th layer Gnd, 5th layer Power, 6th layer Bottom/Components/Signals.

Board Layout

The gerber files and drill file are under http://downloads.qi-hardware.com/hardware/milkymist_one/gerber/rc2/.

PDF file.

Design File in PDF

PCB & Parts Reference

• Milkymist One RC2 bare PCB top.jpg

  Top side PCB

• Milkymist One RC2 bare PCB bottom.jpg

  Bot side PCB

• MM1 RC2 TOP TEXT.png

  Top side Parts Reference

• MM1 RC2 BOT TEXT.png

  Bot side Parts Reference

Different Views of Milkymist One board

• PCB & Parts Reference
• Mm1 rc2 parts on pcb.png

  Top side view

• Mm1 rc2 parts on pcb bot view.png

  Bot side view

• Mm1 rc2 parts on pcb dmx side view.png

  DMX side view

• Mm1 rc2 parts on pcb rca side view.png

  RCA connectors side view

• Mm1 rc2 parts on pcb usb side view.png

  USB connectors side view

• Mm1 rc2 parts on pcb vga side view.png

  VGA connectors side view

QA Outgoing Inspection Report from PCB maker

The following inspections based on your data sent to pcb maker. Those details of inspection report would exactly more than yours.

• 

  To Be Added.

Micro Section of PCB

To be Updated pictures soon.

• Mm1 rc2 pcb stack up.png

  PCB stack up is made at initial stage of routing. In general this data is defined by customer design side not pcb maker. So if you don't request pcb maker follow a specific stack up, they will use the most popular stack up. You should ask pcb maker to provide this data. For MM1 project, we defined this to let pcb maker follow it.

• Mm1 rc2 cut square hole for micro section.png

  PCB Maker used J3 reference to do the microsection inspection.

Links

• Milkymist One RC1 PCB Specification
• PCB Fabrication Technical Information