GPS Free Stack/Notes About Namuru
From Qi-Hardware
< GPS Free Stack
Revision as of 01:13, 5 September 2011 by Kristianpaul (Talk | contribs)
Acknowledgments
Accumulator interrupt is generated after enabling
Registers
(note some register are nor part of namuru upstream)
Channel related registers
| Register | Address | Description |
|---|---|---|
| CH0_PRN_KEY | (0x00) | Gold code sequence |
| CH0_CARRIER_NCO | (0x04) | Local carrier oscilator frequency control |
| CH0_CODE_NCO | (0x08) | Local C/A code oscilator frequency control |
| CH0_CODE_SLEW | (0x0c) | C/A code delay control |
| CH0_I_EARLY | (0x10) | I Early Accumulator |
| CH0_Q_EARLY | (0x14) | Q Early Accumulator |
| CH0_I_PROMPT | (0x18) | I Prompt Accumulator |
| CH0_Q_PROMPT | (0x1c) | Q Prompt Accumulator |
| CH0_I_LATE | (0x20) | I Late Accumulator |
| CH0_Q_LATE | (0x24) | Q Late Accumulator |
| CH0_CARRIER_MEASUREMENT | (0x28) | Carrier cycle count and phase since last TIC |
| CH0_CODE_MEASUREMENT | (0x2c) | Code measurement (code half-chip, code NCO phase) |
| CH0_EPOCH | (0x30) | C/A code count latched on TIC |
| CH0_EPOCH_CHECK | (0x34) | same as EPOCH but no latched to TIC |
| CH0_EPOCH_LOAD | (0x38) | Modify epoch counter |
Status
| STATUS | (0x380) | bit 0 TIC occurred, bit 1 accumulator int, need to be clean manually after read |
| NEW_DATA | (0x384) | data dump one bit per channel |
| TIC_COUNT | (0x388) | Provides TIC down counter value |
| ACCUM_COUNT | (0x38c) | Provides ACCUM INT down counter value |
| CLEAR_STATUS | (0x390) | Clear STATUS flags (need to be cleared) |
| HW_ID | (0x3bc) |
Control
| RESET | (0x3c0) | Software reset (need to be cleared) |
| PROG_TIC | (0x3c4) | Control TIC period value for down counter |
| PROG_ACCUM_INT | (0x3c8) | Control ACCUM INT period (must be less 1 ms) |
