wolfspra1l | azonenberg: about the slx9 board, I assume the board on the pic you showed the other day was soldered by yourself? | 01:25 |
---|---|---|
wolfspra1l | how long did it take you in total? | 01:25 |
azonenberg | wolfspra1l: an hour or so maybe? Not that long | 01:26 |
azonenberg | i spent more time debugging it | 01:26 |
azonenberg | i put the power LED on backwards during assembly (the label o nthe board is correct) | 01:26 |
azonenberg | and R8, originally a 10K resistor, should be a very small value | 01:27 |
azonenberg | i used 10 ohms but its just a pulldown | 01:27 |
azonenberg | i didnt realize the input pin had an internal pullup of around 1K i had to override | 01:27 |
azonenberg | Other than that the board is assembled and working great | 01:27 |
azonenberg | i havent had time to do much with it | 01:27 |
azonenberg | i'm going to assemble the other two today or tomorrow | 01:27 |
azonenberg | I've pretty much finished testing and there are no known bugs in the board at this time | 01:29 |
kristianpaul | ah, wait you dint use a oven finally? all iron? | 01:37 |
wolfspraul | 1h, wow | 02:08 |
wolfspraul | I envy you | 02:08 |
wolfspraul | need to speedup here, I feel so incapable :-) | 02:08 |
azonenberg | wolfspraul: maybe 2 | 04:40 |
azonenberg | kristianpaul: no, it was all reflow | 04:40 |
azonenberg | but i did use an iron for touchup, i bridged a few of the QFP pins with excess paste | 04:41 |
azonenberg | had to use the iron to clean it out | 04:41 |
qi-bot | The firmware build was successful, see images here: http://fidelio.qi-hardware.com/~xiangfu/build-milkymist/milkymist-firmware-20120719-1541/ | 15:25 |
Generated by irclog2html.py 2.9.2 by Marius Gedminas - find it at mg.pov.lt!