| qi-bot | The firmware build was successful, see images here: http://fidelio.qi-hardware.com/~xiangfu/build-milkymist/milkymist-firmware-20120717-1131/ | 11:13 |
|---|---|---|
| qi-bot | The firmware build was successful, see images here: http://fidelio.qi-hardware.com/~xiangfu/build-milkymist/milkymist-firmware-20120717-1555/ | 15:37 |
| azonenberg | wolfspraul: fyi, components + LX9 boards are here | 17:29 |
| azonenberg | will be assembling in a couple of minutes | 17:29 |
| wolfspraul | and I'm going to sleep :-) | 17:35 |
| wolfspraul | just finished a 12 hour day poring over wires | 17:36 |
| wolfspraul | need to digest and continue tomorrow :-) n8 | 17:37 |
| wolfspraul | good luck with the assembly! | 17:37 |
| Fallenou | gn8 | 17:53 |
| kristianpaul | azonenberg: assembled now? := | 18:25 |
| kristianpaul | ) | 18:25 |
| azonenberg | kristianpaul: just came out of the oven | 18:49 |
| azonenberg | first reflow cycle (back side) was perfect | 18:50 |
| azonenberg | second cycle (front side) went decently well but i used too much paste on one component so i got a few bridges | 18:50 |
| azonenberg | and one passive tombstoned | 18:50 |
| azonenberg | quick fixes, thoguh | 18:50 |
| azonenberg | kristianpaul, wolfspraul: http://imgur.com/a/k73TN#0 | 20:07 |
| azonenberg | doing initial tests now but all seems well | 20:07 |
| azonenberg | The ribbon connector for JTAG works beautifully | 20:08 |
| kristianpaul | looks nice | 21:00 |
| Fallenou | sure congratz :) | 21:03 |
| Fallenou | mwalle: I started to implement the new csr :) | 21:03 |
| wpwrak | azonenberg: looks nice. the screws seem massive ;-) | 21:16 |
| azonenberg | wpwrak: lol those are 4-40 | 21:16 |
| kristianpaul | azonenberg: P1 is for LCM? | 21:16 |
| azonenberg | P1 is GPIO | 21:17 |
| azonenberg | Four LVDS pairs, two each way, plus two single-ended lines in the middle (intended for a reference clock) | 21:17 |
| azonenberg | grounds between every signal | 21:17 |
| azonenberg | and 3V3 power for and inputs for bidirectional presence detection | 21:18 |
| qi-bot | The firmware build was successful, see images here: http://fidelio.qi-hardware.com/~xiangfu/build-milkymist/milkymist-firmware-20120717-2340/ | 23:23 |
| --- Wed Jul 18 2012 | 00:00 | |
Generated by irclog2html.py 2.9.2 by Marius Gedminas - find it at mg.pov.lt!